Wet/dry temp sensor package Home Tech support Control Manuals and Instructions

(Type WSxx-SENSOR-WDB)

This pages covers the technical specifications for our standard Wet and Dry Temperature sensor package and how to install this in a kiln.

IMPORTANT:
This sensor package is not desgined for temperatures above 220F or 105C. If you kiln temperatures regularly exceed this you would consider Wet/Dry temperature system.
We do not guarantee that this sensor will work with other kiln control systems.

Specification sheet for Wet and Dry bulb temperature sensor package. (PDF 56KB)

Specification sheet for 4ch transmitter circuit board (used inside sensor package). (191KB)

Installation of sensor on the back wall of the kiln.

 The Temperature and Relative Humidity sensor is normally installed on the back wall of the kiln.

Wiring into control system.

Make sure the Sensor has the correct temperature range for your controller.

We hope this show installation and wiring description of a Temperature and Relative Humidity sensor has been helpful. If you have any questions or need more information, please do not hesitate to contact us.