MiniQuick Firewood Kiln. Home Products Firewood kilns Quick Firewood Kiln

The MiniQuick Firewood Kiln was our first model in our new series of Firewood kiln, which we designed from the beginning for the specific purpose of drying and heat treating firewood.

Export version available here.

MiniQuick%20Firewood%20kiln%20being%20loaded

We were also fortunate to be able to show case this kiln at the Sawlex 2009 Expo in Morgantown WV with an actual firewood drying process. (Detail of the actual demo run here).

**General specifications for MiniQuick Firewood Kiln**
Loading capacity	6 cord	Normally using twelve 1/2 cord baskets. Example
Outside dimensions (LxWxH)	29'x8'5"x11'6"	The wood waste heated model is 8' or 20' longer.
Inside loading dimensions (LxWxH)	22'x7'6"x9'
Turn-key delivery.	YES	Kiln comes completely assembled and only needs to be placed on solid flat surface (concrete normally) and connected to power (and possibly gas)
On-site installation assistance	YES	We will come for one day to finalize installation and educate you on how to run and maintain your kiln.
Fully automatic control system	YES	The process is fully automatic and the USDA upgrade adds more internal wood temp sensors to meet USDA requirements.
Time to meet USDA 160F/75min rules	8-16 hours	This is about the same time for both the gas and wood waste system.
Drying time (including meeting USDA)	18-48 hours	This will depend on specie, starting moisture content, final target moisture content.
Insulation of chamber	R24+	Foam insulation, class 1 fire rated, close cell and non-moisture absorbing
Inside sheeting	Aluminum or Stainless steel (optional)	Standard unit has exposed foam, but the kiln can be upgraded with either Aluminum or Stainless steel inside.
Air circulation	5 or 6HP	Gas unit: 1 x 5HP main fan. Wood waste unit: 4 x 1.5HP.
Heating system	500000 btu/hr	The wood waste heating is 400000-700000 btu/hr depending on the wood waste and moisture content
Power exhaust venting	1.5HP fan	This is to extract the moisture from the chamber during the drying process.
Heat recovery to save energy	YES (only gas model)	This insures that the incoming air is pre-heated using the hot/humid air we are exhausting, thereby reducing energy consumption. THIS IS NOT NEEDED ON WOOD WASTE MODEL AS THE INCOMING AIR ENTERS NEXT TO THE WOOD WASTE HEATING SYSTEM

**Pictures of a wood waste heated MiniQuick firewood kiln.**
Kiln ready for transport
Kiln is in the drying process and power exhaust venting is on.
Kiln seen from the back side with the 34-bin conveyor. Right conveyor has a shed roof installed to prevent show and rain to pile on top of bins after they are loaded.
34-bin conveyor is being loaded with wood waste.
Control panel pictures for operating the kiln.

MiniQuick Firewood Kiln. Home Products Firewood kilns Quick Firewood Kiln

Upcoming events